IAC showing 0 counts at warm idle?

Discuss anything tuning related.

Moderators: Mangus, robertisaar, dex

Post Reply
mike_350_TPI
Posts: 4
Joined: Tue Sep 23, 2008 4:23 pm

IAC showing 0 counts at warm idle?

Post by mike_350_TPI »

Hi,

I have a 1992 Camaro (350 TPI, speed density) and trying to fix a rough, slightly surging idle. I've set the minimum air and TPS. I've also checked for vacuum leaks. However, after warming up the IAC motor keeps going down to 0 counts. It is my understanding that it should not go to 0, but stay around 10-20 counts at warm idle. Upon driving the IAC does open and close with the engine load, so I am thinking it is working right????

Currently I am just using tunerpro to monitor and troubleshoot and am not into tuning or burning chips.

Can anybody familiar with the speed density TPI camaro's please give me some advice on the IAC 0 count issue.

FYI - During my last session at warm idle, the BLM was 136-144 and MAP was ~36pKa. IAC was at 0 counts. Another thing I noticed was the O2 sensor reading was pretty steady while in open loop, but once closed, the value was rather eradic fluctuating from ~250-800mV. Is this normal?

Thanks,

Mike

cstaples
Posts: 21
Joined: Tue Jul 22, 2008 7:20 am

Post by cstaples »

Does the engine idle at the RPM you are calling for?
Sounds like you need to close your TB blade a little.Too much air by the blade.
The o2 readings are correct.Your BLMs are adding fuel.I try to keep mine around 120-128.

Post Reply