Jaybird --> SCT Programming Question

Discuss Ford tuning topics here. Request definitions, discuss parameters, etc.

Moderators: robertisaar, dex

Post Reply
fast_frank_d
Posts: 2
Joined: Fri Aug 15, 2014 5:02 pm

Jaybird --> SCT Programming Question

Post by fast_frank_d » Fri Aug 15, 2014 5:12 pm

Hello All, and thank you in advance for helping me! I am a first time DIY tuner.

I just purchased a Moates Jaybird, and have successfully read my existing tunes from my 4-bank SCT chip on my A9L. I made a couple changes and I am trying to program back to a different bank on the SCT using Flash & Burn. It writes and verifies successfully, but will not actually work on the car. I just get the never-ending fuel pump prime no-start condition.

I am using GUFB.xdf from this website and TunerPro. I've tried several address ranges, including 000000-->00DFFF, 000000-->011FFF, 002000-->011FFF, and nothing is working. I can even read the newly burned tune back and it looks fine in TunerPro. What am I doing wrong?

Thank you so much!
Frank D.

fast_frank_d
Posts: 2
Joined: Fri Aug 15, 2014 5:02 pm

Post by fast_frank_d » Mon Sep 08, 2014 4:02 pm

I finally figured it out! Looks like my previous programmer used files a different size than 56k.

Thanks,
Frank

Post Reply