Yocto Knob!

Submit feature suggestions for future versions of TunerPro here.

Moderators: Mangus, robertisaar, dex

Post Reply
scorp1us
Posts: 4
Joined: Tue Oct 28, 2014 9:23 pm

Yocto Knob!

Post by scorp1us » Sun Apr 09, 2017 3:53 am

I want to tune and drive, but it is impossible for one person to do safely.

YoctoKnob ( http://www.yoctopuce.com/EN/products/us ... yocto-knob ) is a 5 channel input board. What I want is a knob for spark and a knob for fuel.

The device will have two knobs, one for spark and one for fuel.
The TunerPro will be set into follower mode.

Rotating the knob clockwise will increase the value in the current cell, counter clockwise will decrease it. For spark, it will do .1 degrees and the fuel knob will do 1 BLM.

I think this would be huge.

https://learn.sparkfun.com/tutorials/ro ... okup-guide with the exception of going from 10 to 1, this should be easy.

User avatar
Mangus
TunerPro Author
Posts: 1818
Joined: Wed Mar 19, 2003 1:49 pm

Post by Mangus » Fri Apr 21, 2017 12:32 pm

Yes, cool idea. This is something I thought about when the APU1 came out, using the additional 3 channels of A/D for the same purpose.

For your suggestion here, though, it would have to be behind another feature that's near the top of my current list, which is to enable the ability to log from multiple [serial, etc] ports at the same time. This would be necessary in order to take input from your board while also logging the vehicle and (e.g.) a wideband controller.
***************************************
TunerPro Author
1989 Trans Am

Post Reply