Joined: 06 Mar 2013
|Posted: Thu Feb 22, 2018 11:44 am Post subject: Datastream failures / Realterm shows perfect
|My datastream went corrupt after a fixed amount of seconds. 11-17s depending on the baudrate and if I use the "Silent" Macro to stop reading the stream for some ms.
I can produce this failure when I use a value which changes very fast. TPS signal or something else (some ram value which is switching fast).
I checked my output via RealTerm - perfect.
ECM is on my table, engine speed signal generator etc. pp.
External power supply for the KKL cable and the Motronic.
When I stop the datastream and start it again no peaks etc.
It seems at Commads the "baudrate = 0" for default isn't working. When I insert the baudrate I use (like in the Header) it's not happen anymore.
Another "bug", when I open "Edit ADX" during a running stream the stream becomes corrupt after some seconds. The stream shows no peaks, it's more rectangular...
Tracing in a table and data stream slows everything down and same happens after some seconds...
I hope you can help me too improve my toolchain, may my setup is the root cause - may it's some kind of bug?
However, great software!