ECM Firmware updating

Discuss Buell tuning topics here. Request definitions, discuss parameters, etc.
Post Reply
Oldy1
Posts: 1
Joined: Wed Jun 13, 2018 9:22 pm

ECM Firmware updating

Post by Oldy1 » Wed Jun 13, 2018 9:41 pm

I am wanting to install a barometric pressure sensor on my 2008 XB12, but recently discovered the current firmware version BUEOD doesn't have a barometric pressure table, so I need to update my firmware to BUE2D. I have also read that the BUEOD firmware version is considered quite buggy, so it seems like a good move to update. Only problem is that I am unable to locate a HD dealer where I live in Australia, with the capability/knowledge to do an update, guess it's been too long now. I read online that a firmware update can be done using TunerPro. I familiar with TunerPro, but not how to do a firmware update. Can anyone help?

Post Reply