Reading processor binary using Quarterhorse.

Discuss Ford tuning topics here. Request definitions, discuss parameters, etc.

Moderators: robertisaar, dex

Post Reply
jetenginedoctor
Posts: 5
Joined: Sat Feb 19, 2011 7:09 pm

Reading processor binary using Quarterhorse.

Post by jetenginedoctor » Sat Feb 19, 2011 7:39 pm

Howdy,

Does TunerPro support the Quarterhorse device's ability to read the engine controller's factory written calibration yet? I've read conflicting information that TunerPro will/won't support this, and that Clint Garrity's Binary Editor is the only application that will. Mark, Dex, any word on this?

Thanks,
BK

Post Reply